Dell Technologies Networking Foundations (D-NWG-FN-23) Certification Sample Questions

Networking Foundations Dumps, D-NWG-FN-23 Dumps, D-NWG-FN-23 PDF, Networking Foundations VCE, Dell Technologies D-NWG-FN-23 VCE, Dell Technologies Networking Foundations PDF The purpose of this Sample Question Set is to provide you with information about the Dell Technologies Networking Foundations 2023 exam. These sample questions will make you very familiar with both the type and the difficulty level of the questions on the D-NWG-FN-23 certification test. To get familiar with real exam environment, we suggest you try our Sample Dell Technologies Networking Foundations Certification Practice Exam. This sample practice exam gives you the feeling of reality and is a clue to the questions asked in the actual Dell Technologies Certified Networking Foundations 2023 certification exam.

These sample questions are simple and basic questions that represent likeness to the real Dell Technologies D-NWG-FN-23 exam questions. To assess your readiness and performance with real time scenario based questions, we suggest you prepare with our Premium Dell Technologies Networking Foundations Certification Practice Exam. When you solve real time scenario based questions practically, you come across many difficulties that give you an opportunity to improve.

Dell Technologies D-NWG-FN-23 Sample Questions:

01. Given the following customer environment:

- Two switches are connected with two crossover cables

- STP is disabled

What will happen between the two switches?

a) Routing tables on the switches will not update

b) Switches will automatically load the balance between the two links

c) Broadcast storms occur on the switched network

d) MAC forward/filter table will not update on the switch

02. Which command should be used if a switch running OS10 must honor incoming pause frames on an interface?

a) # flowcontrol receive on

b) # ethtool --pause vmnic1 tx on rx on

c) # interface A14 flow-control

d) # flowcontrol receive desired

03. Select the correct command syntax for copying files:

a) send [source-file-url] [destination-file-url]

b) transfer [source-file-url] [destination-file-url]

c) write [source-file-url] [destination-file-url]

d) copy [source-file-url] [destination-file-url]

04. You have been tasked with designing an IPv4 scheme for the 192.168.40.0/24 network. What subnet mask can be used to produce at least five networks that can each support 28 hosts?

a) 255.255.255.128

b) 255.255.255.240

c) 255.255.255.224

d) 255.255.255.192

05. A workstation is assigned an APIPA after boot instead of a DHCP IP address. The technician discovers that the OS6 switch interface starts sending traffic after 30 seconds. What will resolve this issue?

a) Lower the spanning-tree priority

b) Enable PortFast on the switch interface

c) Change STP to PVST

d) Configure a DHCP server on the switch

06. Which command sequence leads to the successful creation of a Layer 3 port channel on an OS10 switch?

a) 1(config-if-po-2)# ip address 192.168.0.0/31

S1(config-if-po-2)# no switchport

b) S1(config-if-po-2)# ip address 192.168.0.0/31

S1(config-if-po-2)# no switchport

c) S1(config-if-po-2)# ip address 192.168.0.0/31

S1(config-if-po-2)# switchport mode IPv4

d) S1(config-if-po-2)# no switchport

S1(config-if-po-2)# ip address 192.168.0.0/31

07. How is outbound traffic distributed when using LACP port channels on OS6 switches?

a) Load balanced per packet using round robin

b) Interfaces are used in active/passive

c) Load balanced using a hash function

d) Traffic overflow is sent to the second interface

08. Which OS10 command is used to enable LLDP transmit on the management interface 1/1/1?

a) # lldp open

b) # lldp transmit

c) # lldp enable

d) # lldp start

09. A network admin wants to secure SNMP access to the switch using an ACL named SPLUNKSRV. Which command will accomplish this task?

a) snmp-server community admin14344 rw SPLUNKSRV

b) snmp-server community admin14344 SPLUNKSRV rw

c) snmp-server community admin14344 allow SPLUNKSRV

d) snmp-server community admin14344 permit SPLUNKSRV

10. What is the network address for the IP address 10.5.6.73 with subnet mask 255.255.255.192?

a) 10.5.6.0

b) 10.5.6.73

c) 10.5.6.64

d) 10.0.0.0

Answers:

Question: 01 Answer: c	Question: 02 Answer: a	Question: 03 Answer: d	Question: 04 Answer: c	Question: 05 Answer: b
Question: 06 Answer: d	Question: 07 Answer: c	Question: 08 Answer: b	Question: 09 Answer: a	Question: 10 Answer: c

Note: For any error in Dell Technologies Certified Networking Foundations 2023 (D-NWG-FN-23) certification exam sample questions, please update us by writing an email on feedback@edusum.com.