Check Point CCSE (156-315.81.20) Certification Sample Questions

CCSE Dumps, 156-315.81.20 Dumps, 156-315.81.20 PDF, CCSE VCE, Check Point 156-315.81.20 VCE, Check Point CCSE R81.20 PDFThe purpose of this Sample Question Set is to provide you with information about the Check Point Security Expert exam. These sample questions will make you very familiar with both the type and the difficulty level of the questions on the 156-315.81.20 certification test. To get familiar with real exam environment, we suggest you try our Sample Check Point CCSE Certification Practice Exam. This sample practice exam gives you the feeling of reality and is a clue to the questions asked in the actual Check Point Certified Security Expert (CCSE) R81.20 certification exam.

These sample questions are simple and basic questions that represent likeness to the real Check Point 156-315.81.20 exam questions. To assess your readiness and performance with real time scenario based questions, we suggest you prepare with our Premium Check Point CCSE Certification Practice Exam. When you solve real time scenario based questions practically, you come across many difficulties that give you an opportunity to improve.

Check Point 156-315.81.20 Sample Questions:

01. Which command will allow you to see the interface status?
a) cphaprob stat
b) cphaprob –a if
c) cphaprob –I interface
d) cphaprob interface
02. After finishing installation admin John likes to use top command in expert mode. John has to set the expert-password and was able to use top command. A week later John has to use the top command again, He detected that the expert password is no longer valid.
What is the most probable reason for this behavior?
a) "write memory" was not issued on clish
b) changes are only possible via SmartConsole
c) "save config" was not issued in expert mode
d) "save config" was not issued on clish
03. Your manager asked you to check the status of SecureXL, and its enabled templates and features. What command will you use to provide such information to manager?
a) fwaccel stats
b) fw acces stats
c) fwaccel stat
d) fw accel stat
04. What API command below creates a new host object with the name "My Host" and IP address of ""?
a) set host name "My Host" ip-address ""
b) new host name "My Host" ip-address ""
c) create host name "My Host" ip-address ""
d) mgmt_cli -m add host name "My Host" ip-address ""
05. What command is used to manually failover a cluster during a zero downtime upgrade?
a) cpstop
b) clusterXL_admin down
c) set cluster member down
d) set clusterXL down
06. Where can you see and search records of action done by R80 SmartConsole administrators?
a) In the Logs & Monitor, logs, select “Audit Log View”
b) In Smartlog, all logs
c) In SmartView Tracker, open active log
d) In SmartAudit Log View
07. Which packet info is ignored with Session Rate Acceleration?
a) source port ranges
b) source ip
c) source port
d) same info from Packet Acceleration is used
08. You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don’t have a budget to perform a hardware upgrade at this time. To optimize  drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?
a) fw ctl multik pq enable
b) fw ctl multik dynamic_dispatching set_mode 9
c) fw ctl multik dynamic_dispatching on
d) fw ctl multik set_mode 9
09. Alice & Bob are going to use Management Data Plane Separation and therefore the routing separation needs to be enabled. Which of the following command is true for enabling the Management Data Plane Separation (MDPS):
a) set mdps split brain on
b) set mdps split plane on
c) set mdps mgmt plane on
d) set mdps data plane off
10. What are the two ClusterXL Deployment options?
a) Distributed and Full High Availability
b) Broadcast and Multicast Mode
c) Distributed and Standalone
d) Unicast and Multicast Mode


Question: 01
Answer: c
Question: 02
Answer: d
Question: 03
Answer: c
Question: 04
Answer: d
Question: 05
Answer: b
Question: 06
Answer: a
Question: 07
Answer: b
Question: 08
Answer: d
Question: 09
Answer: c
Question: 10
Answer: a

Note: For any error in Check Point Certified Security Expert (CCSE) R81.20 (156-315.81.20) certification exam sample questions, please update us by writing an email on

Rating: 4.8 / 5 (245 votes)